Home > Quality Control & IS Codes

IS Codes For Drainage and Sanitation

Er. Parbhakar Dwivedi
0
 

       

IS Codes For Drainage and Sanitation
IS SP 35 : 1987 Handbook on water supply and drainage with special emphasis on plumbing
IS 458 : 2003 Specification for precast concrete pipes (with and without reinforcement) (fourth revision)
IS 651 : 1992 Specification for salt glazed stoneware pipes and fittings (fifth revision)
IS 771 Specification for glazed fire-clay sanitary appliances
IS 771 (Part 1): 1979 Specification for glazed fire-clay sanitary appliances (Part 1) : General requirements (second revision)
IS 771 (Part 2): 1985 Specification for glazed fire-clay sanitary appliances (Part 2): Specific requirements of kitchen and laboratory sinks (third revision)
IS 771 (Part 3/Sec 1) 1979 Specification for glazed fire-clay sanitary appliances (Part 3) Section 1 : Specific requirements of urinals, Section 1 Slab urinals (second revision)
IS 771 (Part 3/Sec 2) : 1985 Specific requirements of urinals, Section 2 Stall urinals (third revision)
IS 771 (Part 4) : 1979 Specific requirements of post mortom slabs (second revision)
IS 771 (Part 5) : 1979 Specific requirements of shower trays (second revision)
IS 771 (Part 6) : 1979 Specific requirements of bed-pan sinks (second revision)
IS 771 (Part 7) : 1981 Specific requirements of slop sinks (second revision)
IS 772 : 1973 Specification for general requirements for enameled cast iron sanitary appliances (second revision)
IS 773 : 1988 Specification for enameled cast iron water closets railway coaching stock type (fourth revision)
IS 774 : 1984 Specification for flushing cistern for water closets and urinals (other than plastic cistern) (fourth revision)
IS 775 : 1970 Specification for cast iron brackets and supports for wash basins and sinks (second revision)
IS 783 : 1985 Code of practice for laying of concrete pipes (first revision)
IS 784 : 2001 Specification for prestressed concrete pipes (including specials) (second revision)
IS 1239 (Part 1) : 2004 Steel tubes, tubulars and other wrought steel fittings: Part 1 Steel tubes (sixth revision)
IS 1536 : 2001 Specification for centrifugally cast (spun) iron pressure pipes for water, gas and sewage (fourth revision)
IS 1537 : 1976 Specification for vertically cast iron pressure pipes for water, gas and sewage (first revision)
IS 1538 : 1993 Specification for cast iron fittings for pressure pipes for water, gas and sewage (third revision)
IS 1592 : 2003 Specification for asbestos cement pressure pipes and joints (fourth revision)
IS 1626 Specification for asbestos cement building pipes and pipe fittings, gutters and gutter fittings, and roofing fittings
IS 1626 (Part 1) : 1994 Pipes and pipe fittings (second revision)
IS 1626 (Part 2) : 1994 Gutters and gutter fittings (second revision)
IS 1626 (Part 3) : 1994 Roofing accessories (second revision)
IS 1700 : 1973 Specification for drinking fountains (first revision)
IS 1726 : 1991 Specification for cast iron manhole covers and frames (third revision)
IS 1729 : 2002 Cast iron/ductile iron drainage pipes and pipe fittings for over ground non-pressure pipeline socket and spigot series (second revision)
IS 1742 : 1983 Code of practice for building drainage (second revision)
IS 1916 : 1989 Specification for steel cylinder with concrete lining and coating (first revision)
IS 2064 : 1993 Code of practice for selection, installation and maintenance of sanitary appliances (second revision)
IS 2212 : 1991 Code of practice for brickwork (first revision)
IS 2326 : 1987 Specification for automatic flushing cisterns for urinals (second revision)
IS 2470 (Part 1) : 1985 Code of practice for installation of septic tanks Design criteria and construction (second revision)
IS 2470 (Part 2) : 1985 Secondary treatment and disposal of septic tank effluent (second revision)
IS 2527 : 1984 Code of practice for fixing rainwater gutters and downpipes for roof drainage (first revision)
IS 2548 Specification for plastic seats and covers for water closets
IS 2548 (Part 1) : 1996 Thermoset seats and covers (fifth revision)
IS 2548 (Part 2) : 1996 Thermo plastic seats and covers (fifth revision)
IS 2556 Specification for vitreous sanitary appliances (vitreous china)
IS 2556 (Part 1) : 1994 General requirements (third revision)
IS 2556 (Part 2) : 1994 Specific requirements of wash- down water closets (fourth revision)
IS 2556 (Part 3) : 1994 Specific requirements of squatting pans (fourth revision)
IS 2556 (Part 4) : 1994 Specific requirements of wash basins (third revision)
IS 2556 (Part 5) : 1994 Specific requirements of laboratory sinks (third revision)
IS 2556 (Part 6) : 1995 Specific requirements of urinals and partition plates (fourth revision)
IS 2556 (Part 7) : 1995 Specific requirements of accessories for sanitary appliances (third revision)
IS 2556 (Part 8) : 1995 Specific requirements of siphonic wash down water closets (fourth revision)
IS 2556 (Part 9) : 1995 Specific requirements of bidets (fourth revision)
IS 2556 (Part 14) : 1995 Specific requirements of integrated squatting pans (first revision)
IS 2556 (Part 15) : 1995 Specific requirements of universal water closets (first revision)
IS 2556 (Part 16) : 2002 Specific requirements for wash down wall mounted water closets
IS 2556 (Part 17) : 2001 Specific requirements for wall mounted bidets
IS 3006 : 1979 Specification for chemically resistant salt glazed stoneware pipes and fittings (first revision)
IS 3114 : 1994 Code of practice for laying of cast iron pipes (second revision)
IS 3489 : 1985 Specification for enameled steel bath tubs (first revision)
IS 3989 : 2009 Specification for centrifugally cast (spun) spigot and socket soil, waste ventilating and rainwater pipes, fittings and accessories (third revision)
IS 4111(Part 1) : 1986 Code of practice for ancillary structures in sewerage system : Part 1 Manholes (first revision)
IS 4127 : 1983 Code of practice for laying of glazed stoneware pipes (first revision)
IS 4350 : 1967 Specification for concrete porous pipes for under drainage
IS 5329 : 1983 Code of practice for sanitary pipe work above ground for buildings (first revision)
IS 5455 : 1969 Specification for cast iron steps for manholes
IS 6411 : 1985 Specification for gel-coated glass fibre reinforced polyester resin bath tubs (first revision)
IS 6530 : 1972 Code of practice for laying of asbestos cement pressure pipes
IS 6908 : 1991 Specification for asbestos cement pipes and fittings for sewerage and drainage (first revision)
IS 7181 : 1986 Specification for horizontally cast iron double flanged pipes for water, gas and sewage (first revision)
IS 7231 : 1994 Specification for plastic flushing cisterns for water closets and urinals (second revision)
IS 7319 : 1974 Specification for perforated concrete pipes
IS 8718 : 1978 Specification for vitreous enameled steel kitchen sinks
IS 8727 : 1978 Specification for vitreous enameled steel wash basins
IS 9076 : 1979 Specification for vitreous integrated squatting pans for marine use
IS 10446 : 1983 Glossary of terms relating to water supply and sanitation
IS 11208 : 1985 Guidelines for registration of plumbers
IS 11246 : 1992 Specification for glass fibre reinforced polyester resins (GRP) squatting pans (first revision)
IS 12592 : 2002 Specification for precast concrete manhole covers and frames (first revision)
IS 13983 : 1994 Specification for stainless steel sinks for domestic purposes
IS 13592 : 2013 Specification for UPVC pipes for soil and waste discharge systems inside buildings including ventilation and rainwater system (first revision)
IS 14333 : 1996 Specification for high density polyethylene pipe for sewerage
IS 14735 : 1999 Specification for unplasticized polyvinyl chloride (UPVC) injection moulded fittings for soil and waste discharge system for inside and outside buildings including ventilation and rainwater system
IS 14961 : 2001 Guidelines for rainwater harvesting in hilly areas by roof water collection system
IS 15328 : 2003 Unplasticized non-pressure polyvinyl chloride (PVC-U) pipes for use in underground drainage and sewerage systems
IS 15792 : 2008 Guidelines for artificial recharge to ground water
IS 15797 : 2008 Guidelines for roof top rainwater harvesting

Sponsored

PD Consulting Engineers Pvt. Ltd. Transforming construction for a new generation "Cost, Quality & Project management"

QS & Cost management, Bill Checking / Audit, Technical Auditors, Valuation, Contract and Tendering, Project Management, Project Planning, Quality Control, Consulting Engineers, Structural Consultancy

Close


Comment:

Name:

Email:

Civil N Construction Blog



Relevant Topics

Tests for stones

Tests For Limestone

Tests Of Mortar

Specifications For Water (IS 456)

Determine Flexure Strength Of Concrete

Procedure For Test Of Silt Content In Sand

Determination Of Dry Density Of Soil Core Cutter Method

Procedure For Determination Of Aggregate Crushing Value

Procedure For Slump Test For Concrete

Determination Of Water Absorption Coarse Aggregate Format

Initial And Final Setting Test Of Cement Format

Concrete Quantite Register Grade Wise Summary Format

Procedure For Determination Of Water Content In Soil

Procedure For Determination Of Elongation Index Of Coarse Aggregate

Aggregate Crushing Value Test Format

Water Test Report Register Format

Testing Of Cement Testing Of Cement Field Test

Procedure For Sieve Analysis Of Fine Aggregates

Compressive Strength Test Of Bricks Format

Efflorescence Status Of Bricks Format

Procedure For Determination Of Flakiness Index Of Coarse Aggregate

Sieve Analysis For Coarse Aggregate Format

Procedure For Determination Standard Consistency Of Cement

Method Of Sampling Of Cement

Verification Of Compression Testing Machine Oil Leakage

Rolling Margin Register Format

Determination Of Specific Geavity Fine Aggregate Format

Concrete Quantity Register Pouring Details Format

Procedure For Sieve Analysis Of Coarse Aggregates

Verification Of Cube Moulds

Dimension Test Of Bricks Format

Slump Ans Temp Register For Concrete Format

Procedure For Filling Cubes

Consistency Of Standared Cement Paste Format

Rolling Margin Register Total Quantity Format

Procedure For Determination Of Aggregate Impact Value

Determination Of Specific Gravity And Water Absorption Of Fine Aggregates

Procedure For Compressive Strength Testing For Concrete

Incoming Material Receiving Register Format

Determination Of Specific Gravity And Water Absorption Of Coarse Aggregate

Internal Qa And Qc Audit Observation Format

Verification Of Sieves

Verification Of Mechanical Weigh Balance

Determination Of Water Absorption Of Bricks

List Of Site Laboratory Equipment

Flakiness Index Of Coarse Aggregate Format

Determination Of Efflorescence Of Bricks

Determination Of Specific Gravity Coarse Aggregate Format

Procedure For Determination Fineness Of Cement

Concrete Cube Register Format

Concrete Quantity Register Month Wise Summary Format

Water Absorption Test Of Bricks Format

Moisture Correction Format

List Of Records To Be Maintained Qc Qa

Fineness Test Of Cement Format

Procedure For Determination Compressive Strength Test Of Cement

Aggregate Impact Value Test Format

Elongation Index Of Coarse Aggregate Format

Procedure For Determination Of Compressive Strength Of Bricks

Material Test Plan Civil Works

Soundness Test Of Cement Format

Procedure For Determination Setting Time Of Cement

Fineness Test Of Flyash Format

Field Dry Density Of Soil By Core Cutter Method Format

Bend And Reband Test Of Steel Format

Determination Of Water Absorption Fine Aggregate Format

Compressive Strength Test Of Cement Format

Sieve Analysis For Fine Aggregate Format

Verification Of Pan Balance

Calibration Plan

IS Codes for landscape developement and IS Codes for approaches to sustainability

IS Codes for steel and its alloys

IS Codes for stones

is-codes-for-structural-sections

IS Codes for threaded fasteners rivets and nails

IS Codes for timber bamboo and other lignocellulosic building materrials

IS Codes for waterproofing and damp proofing materials

IS Codes for building chemicals

IS Codes for building lime & products

IS Codes for clay & stabilized soil products

IS Codes for doors windows & ventilators

IS Codes for floor covering roofing & other finishes

IS Codes for glass & mortar

IS Codes for paints and allied products

IS Codes for polymers plastics & geosynthetics geotextiles

IS Codes gypsum based materials

IS Codes Safety and IS Codes For Demolition and Dismantling

IS Codes for Roofing

IS Codes for Steel Work

IS Codes for Finishing

IS Codes for Flooring

IS Codes for Stone Work

IS Codes for Wood Work

IS Codes for Brick Work

IS Codes for RCC Work

IS Codes for ConcreteWork

IS Codes for Mortar

IS Codes for composite matrix products

IS Codes for cement & concrete

IS Codes for builder's hardware

IS Codes for aluminium & other light metals & their alloys

Quality Control (QC), Quality Assurance (QA), Quality Control Utilizes Tools and techniques

Quality Assurance manual (QAM), Quality Assurance Plan (QAP)

Quality Audits, Quality Assurance Formulations

Quality Control Method Statement, Pre- Construction Stage, Construction Stage, Post- Construction Stage

Quality Control Plan, Quality Control System, Quality control of materials, Quality control of workers, Quality control of execution

IS Codes for air conditioning heating and mechanical ventilation

IS Codes for drainage and sanitation

IS Codes for electrical and allied installations

is codes for firefighting and life safety

IS Codes for lighting and natural ventilation

IS Codes for solid waste management and IS Codes for gas supply

is codes for thermal insulation materials

IS Codes for water supply

is codes for welding electrodes and wires

IS Codes for electrical wiring fittings and accessories

IS Codes for conductors & cables

IS Codes for sanitary appliances and water fittings

Sponsored

PD Consulting Engineers Pvt. Ltd. Transforming construction for a new generation "Cost, Quality & Project management"

QS & Cost management, Bill Checking / Audit, Technical Auditors, Valuation, Contract and Tendering, Project Management, Project Planning, Quality Control, Consulting Engineers, Structural Consultancy

Close